Instructions:
- Unscrew the screw [ 4 ] on the Rear Air Plug [ 3 ] and remove the Rear Air Plug [ 3 ] as well as the original Rear Plate [ 2 ]
- Take out the two screws on the inside of the T15 Lower Receiver that connect the original Rear ASA with the Receiver.
ATTENTION! On the inside of the original Rear ASA you will find the Shroud Mounting Screw O-ring [ 6 ] . Do not lose it - Put the Shroud Mounting Screw O-ring [ 6 ] into the Drop ASA – THE SLIM [ 7 ] .
- Put the Rear Plate [ 2 ] and the Rear Air Plug [ 3 ] back in. (Step 1 )
- Place the thin foam rubber plate [ 5 ] between Rear Plate [ 2 ] and Drop ASA – THE SLIM [ 7 ] – preferably on the Drop ASA
- Connect the Drop ASA – THE SLIM [ 7 ] and the T15 Lower Receiver with the included extra long screws [ 1 ] . (Step 2 )
Additionally: A spare ASA O-Ring is included, because you can never have enough of those
Contents:
- 1x Drop ASA – THE SLIM
- 2x M5 screws
- 1x thin rubber foam plate
- 1x spare Shroud Mounting Screw O-ring
- 1x spare ASA o-ring
- 1x instruction manual
- 1x quality card
Optional:
The Rear Plate can be replaced by a Sling Plate Shaft or Eye Shaft. (Not included. )
Warnings:
Manual and warnings are to be read before any use.
- Read and understand all cautions, warnings and manuals before using and handling any paintball guns and paintball gun accessories.
- Installation and maintenance are only to be carried out by authorized personnel.
- Careless installation, use or misuse may result in severe damage to the paintball gun and any or all accessories.
- Careless installation, use or misuse may result in serious bodily injury or death.
- Paintball guns and Drop ASA may only be used when proper eye, face and ear protection is worn by the user and everyone within range.
- This is not a toy!
- To be used only with an 850psi regulator
- Not to be used outside of the temperature range of -15 °C to 50 °C.
- To be used only in dry conditions (no oil or water).
- Just for paintball certified pressure systems (HPA).
- Check for damages of defects before and after any use.
- Do not use when any damages or defects are detected.
Contact the manufacturer at support@tacticalsportsparts.com - Keep exposed skin clear of any and all escaping gases while installing or taking off the pressure system (HPA) or when the paintball gun or the air system is loosing pressure. Pressurized air, CO2 and nitrogen gases are very cold and may cause frostbite under certain conditions.
- If any problems occur with the paintball gun, please contact the manufacturer of the paintball gun.
- If any problems occur with the HPA pressure system, please contact the manufacturer of the HPA pressure system.
- Must be 18 years of age or older to use and handle any paintball gun and paintball gun accessories without the supervision of an adult or parent.
- Please conform to all local, regional and state regulations and laws with regards to installing, using, handling and operating this product.
- Please use common sense and have fun.
